Claas C450 Folding Do Mega Medion (431) Combines Operator Manual ES

File List:

00 0299 843 0.pdf

00 0299 ​​843 0.pdf:

Introduction
Introduction
Foreword
Attention
Especially important
Identification plate/serial number
Security measures
Security measures
Warning and danger signs
Proper handling of the machine
General instructions for safety and accident prevention
Safety supports
Safety supports
Reel safety support
Install the safety support of the windlass
Remove and store the reel support
Safety decals with warning symbols
Technical data
Weights / Measurements / Safety device
Weights / Measurements
Safety device
Adjusting the sliding clutches
Before start-up
Tasks to be carried out before the first start-up
Advance lighting in road traffic
Advance lighting in road traffic
Change forward lighting
Cutting mechanism cylinder
Additional equipment
Additional weights
MEDION 340 – 310 / MEGA 360 / 350
Steering wheel fluil Assemble the canopy weights
Piece volume – hood weights
Parts volume – steering axle weights
Steering axle weights
Install the steering axle weights (additional equipment)
Assembly and handling
Assemble additional equipment
Install the stops on the feed channel
Volume of parts – assembly
Assemble the stops
Fix the cutting mechanism laterally
Modify the “Auto-Contour” cutting mechanism for machines without Auto-Contour
Assemble the switch device and the advance lighting
Trim the MEGA 360 / MEDION 340 key
Adjust additional forward spotlights
Assemble the cutting mechanism
Tip the cutting mechanism out of the transport position
Assembling and disassembling the cutting mechanism
Assembling the cutting mechanism – folded – (cutting mechanism in transport position)
Adjust the cutting mechanism (cutting mechanism without Auto-Contour)
Connect the hydraulic hoses
Connect the plug
Changing the cuttiechanfrom transport position to working position
Changing the cutting mechanism from working position to transport position
Disassemble the cutting mechanism – folding –
Assemble the cutting mechanism – deployed – (cutting mechanism in working position)
Connect the cardan shafts
Connect the hydraulic hoses
Connect the plug
Dismantle the cutting mechanism – deployed – (cutting mechanism in working position)
Cutting mechanism adjustments
harvest dividers
harvest lifters
cutting blade
Pinwheel
Reel speed
Feed auger
Cutter mechanism skids
Incident
Possible cause and solution
Maintenance
Transmission
Blade transmission/drive
Oil quantity:
(Fig. 1, 2)
(Fig. 2)
Check the oil level:
Bevel gear for driving the reel
Blade drives
Transmission chain tensioning
Clean the locking cylinder rails
Adjust double fingers
Greasing scheme
Lubricants and indications
Alphabetical index
Greasing scheme