Komatsu WB140-2, WB150-2 Backhoe Loader Operation and Maintenance Manual WEAM000902

Description

• Model List:
  • WB140-2 Backhoe Loader
  • WB150-2 Backhoe Loader

• 1. MAIN MENU
• 2. COVER
• 3. TABLE OF CONTENTS
• 4. FOREWORD
• 5. INFORMATION ON SAFETY
• 6. INTRODUCTION
• 7. INTENDED USES
• 8. IMPROPER OR UNAUTHORIZED USES
• 9. MAIN CHARACTERISTICS
• 10. RUNNINGIN
• 11. PRODUCT IDENTIFICATION
• 12. MACHINE SERIAL NUMBER
• 13. MACHINE IDENTIFICATION PLATE
• 14. ENGINE SERIAL NUMBER AND EMISSION LABEL
• 15. FRONT AXLE SERIAL NUMBER
• 16. REAR AXLE SERIAL NUMBER
• 17. TRANSMISSION SERIAL NUMBER
• 18. CAB SERIAL NUMBER
• 19. CANOPY SERIAL NUMBER
• 20. SERIAL NUMBERS AND DEALERS ADDRESS
• 21. SAFETY AND ACCIDENT PREVENTION
• 21.1. GENERAL PRECAUTIONS
• 22. PRECAUTIONS
• 22.1. PRECAUTIONS TO BE TAKEN BEFORE STARTING THE ENGINE
• 22.2. PRECAUTIONS TO BE TAKEN WHEN WORKING
• 22.3. TRANSPORTING THE MACHINE ON OTHER VEHICLES
• 22.4. THE BATTERY
• 22.5. PRECAUTIONS FOR EMERGENCY RECOVERY
• 22.6. PRECAUTIONS TO BE TAKEN DURING MAINTENANCE
• 22.7. SAFETY PLATES
• 23. TECHNICAL SPECIFICATIONS
• 23.1. TECHNICAL DATA
• 24. DESCRIPTION AND USE OF THE MACHINE
• 24.1. SAFETY LOCKS
• 24.2. GENERAL VIEWS
• 24.3. INSTRUMENTS AND CONTROLS
• 24.4. FUSES AND RELAYS
• 24.5. GUARDS, CAB AND DRIVERS SEAT
• 24.6. USE OF THE MACHINE
• 24.7. PARKING THE MACHINE
• 24.8. STOPPING THE ENGINE
• 24.9. TRANSPORTING THE MACHINE ON OTHER SURFACES
• 24.10. PRECAUTIONS TO BE TAKEN IN THE COLD SEASON
• 24.11. PRECAUTIONS TO BE TAKEN IN THE WARM SEASON
• 24.12. USING THE MACHINE AS A LOADER
• 24.13. USING THE MACHINE AS AN EXCAVATOR
• 24.14. TROUBLESHOOTING
• 25. MAINTENANCE
• 25.1. GUIDE TO MAINTENANCE
• 25.2. MAINTENANCE NOTES
• 25.3. FUEL, COOLANT AND LUBRICANTS
• 25.4. NUT AND BOLT TIGHTENING TORQUES
• 25.5. MAINTENANCE PLAN
• 25.6. LONG PERIODS OF INACTIVITY
• 26. AUTHORIZED OPTIONAL EQUIPMENT
• 26.1. AUTHORIZED OPTIONAL EQUIPMENT
• 26.2. FRONT EQUIPMENT RAPID COUPLING DEVICES
• 26.3. MULTIPURPOSE BUCKET
• 26.4. PALLET FORKS
• 26.5. BACKHOE TELESCOPIC ARM
• 26.6. ARRANGEMENT FOR THE INSTALLATION OF THE DEMOLITION HAMMER
• 26.7. ARRANGEMENT FOR THE OPERATION OF OPERATIONAL EQUIPMENT WIHT UNIDIRECTIONAL OIL FLOW
• 26.8. ARRANGEMENT FOR THE INSTALLATION OF THE CLAMSHELL BUCKET
• 26.9. ARRANGEMENT FOR THE INSTALLATION OF THE MANUAL HYDRAULIC HAMMER
• 26.10. LOAD STABILIZER SYSTEM (LSS) (OPTIONAL)
• 26.11. AIR CONDITIONER (OPTIONAL)