Bomag BW 154 AP – 4i, BW 174 AP – 4i Electrics Documentation

Description

• Model List:
  • BW 154 AP – 4i Electrics
  • BW 174 AP – 4i Electrics

• 1. Table of contents
• 2. Confirmation of changes
• 2.1. Document
• 2.2. Software
• 3. Displayed monitoring activities with fault reactions
• 4. Known faults
• 5. How to proceed when replacing components
• 5.1. How to proceed when replacing an ESX control (A34)
• 5.2. How to proceed when replacing a data collector module (A 80)
• 5.3. How to proceed when replacing a travel pump
• 5.4. How to proceed when replacing a steering valve
• 5.5. How to proceed when replacing a steering angle sensor
• 5.6. Which components can be replaced without a subsequent adjustment procedure
• 5.7. Software update
• 6. Functions of the ESX control
• 6.1. General display functions and operation
• 6.1.1. Calling up service mode
• 6.1.2. Entering input codes
• 6.2. Driving against the closed brake
• 6.3. Setting the machine type
• 6.4. Adjusting the crossslope sensor
• 6.5. Calibration of the angle transducers
• 6.6. Adjusting the angle transducers
• 6.7. Automatic detection of surge currents on steering valves
• 6.8. Automatic detection of surge currents in travel system
• 6.9. Fault log display and delete
• 6.9.1. Deleting all stored faults
• 6.10. Adjusting the chip spreader type
• 6.11. Activating edge cutting units
• 6.12. Initializing the LCDisplay
• 6.13. Inspection of DPFsystem on Kubota engines
• 7. Description of signals on the electronic modules
• 7.1. Description of the signals on the ESXcontrol
• 7.2. Description of signals on the data collector
• 7.3. Description of signals on the travel lever
• 7.4. Description of Signals on Display Module
• 7.5. Description of Signals on the BLM IO Module
• 8. Description of fault codes on the ESX control
• 8.1. Overview
• 8.2. Description of fault reactions
• 8.3. Note codes