Bomag BW 120 AC-5 Combination Roller Operating and Maintenance Instructions 00820131

Description

• Model List:
  • BW 120 AC-5 Combination Roller

• 1. Table of contents
• 2. Introduction
• 2.1. Foreword
• 2.2. Machine type plate and engine type plate
• 3. Technical data
• 3.1. Noise and vibration data
• 4. Concerning your safety
• 4.1. Basic prerequisites
• 4.2. Definition of responsible persons
• 4.3. Fundamentals for safe operation
• 4.4. Handling fuels and lubricants
• 4.5. Loading / transporting the machine
• 4.6. Startup procedure
• 4.7. Driving the machine working operation
• 4.8. Refuelling
• 4.9. Regeneration of exhaust gas aftertreatment system
• 4.10. Emergency procedures
• 4.11. Maintenance work
• 4.12. Repair
• 4.13. Signage
• 5. Indicators and control elements
• 5.1. Drivers stand
• 5.2. Outside of machine
• 5.3. Engine compartment
• 6. Checks prior to start up
• 6.1. Notes on safety
• 6.2. Visual inspections and function tests
• 6.3. Checking the engine oil level
• 6.4. Checking the fuel level, topping up fuel
• 6.5. Checking the hydraulic oil level
• 6.6. Checking the hydraulic oil filter
• 6.7. Checking the coolant level
• 6.8. Checking the air filter
• 6.9. Checking the water level, topping up
• 6.10. Checking the emulsion level, topping up
• 6.11. Checking, adjusting the scrapers
• 6.12. Checking wheels and tyres
• 7. Operation
• 7.1. Settingup the work place
• 7.2. Electronic immobilizer
• 7.3. Starting the engine
• 7.4. Travel operation
• 7.5. Working with vibration
• 7.6. Water spraying system
• 7.7. Regeneration of exhaust gas aftertreatment system
• 7.8. Crabwalk
• 7.9. Parking the machine in secured condition
• 7.10. Edge cutter
• 7.11. Chip spreader
• 7.12. Emergency procedures
• 8. Loading / transporting the machine
• 8.1. Prepare for transport
• 8.2. Loading the machine
• 8.3. Lashing the machine to the transport vehicle
• 8.4. Loading by crane
• 8.5. After transport
• 9. Maintenance
• 9.1. Preliminary remarks and safety notes
• 9.2. Fuels and lubricants
• 9.3. List of fuels and lubricants
• 9.4. Runningin instructions
• 9.5. Maintenance Table
• 9.6. Every 50 operating hours
• 9.7. Every 250 operating hours
• 9.8. Every 500 operating hours
• 9.9. Every 1000 operating hours
• 9.10. Every 2000 operating hours
• 9.11. Every 3000 operating hours
• 9.12. As required
• 10. Troubleshooting
• 10.1. Preliminary remarks
• 10.2. Starting the engine with jump leads
• 10.3. Fuse assignment
• 10.4. Fault code display
• 10.5. Engine faults
• 10.6. Trouble shooting ECONOMIZER
• 11. Disposal
• 11.1. Final shutdown of machine