Description
-
Model List:
- 930E-2SE Dump Truck
- 0.1. TABLE OF CONTENTS
- 0.2. TRUCK MODEL ILLUSTRATION
- 0.3. ABOUT THIS MANUAL
- 0.4. STANDARD CHARTS AND TABLES
- 1. SAFETY
- 1.1. GENERAL SAFETY
- 1.2. PRECAUTIONS DURING OPERATION
- 1.2.1. OPERATING MACHINE
- 1.2.2. TOWING
- 1.2.3. BATTERY
- 1.3. PRECAUTIONS FOR MAINTENANCE
- 1.3.1. BEFORE CARRYING OUT MAINTENANCE
- 1.3.2. DURING MAINTENANCE
- 1.3.3. TIRES
- 1.3.4. ADDITIONAL JOB SITE RULES
- 1.4. WHEN REPAIRS ARE NECESSARY
- 1.4.1. SPECIAL PRECAUTIONS FOR WORKING ON A 930E TRUCK
- 1.5. WARNING, CAUTION, AND INSTRUCTION PLATES/DECALS
- 2. OPERATION
- 2.1. OPERATING INSTRUCTIONS
- 2.1.1. PREPARING FOR OPERATION
- 2.1.2. SAFETY IS THINKING AHEAD
- 2.1.3. AT THE TRUCK GROUND LEVEL WALK AROUND INSPECTION
- 2.2. ENGINE STARTUP SAFETY PRACTICES
- 2.3. AFTER ENGINE HAS STARTED
- 2.4. MACHINE OPERATION SAFETY PRECAUTIONS
- 2.5. MACHINE OPERATION ON THE HAUL ROAD
- 2.6. STARTING ON A GRADE WITH A LOADED TRUCK
- 2.7. PASSING
- 2.8. LOADING
- 2.9. DUMPING
- 2.10. TOWING
- 2.11. SAFE PARKING PROCEDURES
- 2.12. NORMAL ENGINE SHUTDOWN PROCEDURE
- 2.13. DELAYED ENGINE SHUTDOWN PROCEDURE
- 2.14. SUDDEN LOSS OF ENGINE POWER
- 2.15. RESERVE ENGINE OIL SYSTEM
- 2.16. OPERATOR CAB AND CONTROLS
- 2.16.1. STEERING WHEEL AND CONTROLS
- 2.16.2. DYNAMIC RETARDER/SERVICE BRAKE PEDAL
- 2.16.3. ACCELERATOR (THROTTLE) PEDAL
- 2.16.4. HEATER/AIR CONDITIONER VENTS
- 2.16.5. HEATER/AIR CONDITIONER COMPARTMENT AND CONTROLS
- 2.16.6. GRADE SPEED CHART
- 2.16.7. CENTER CONSOLE CONTROLS AND FEATURES
- 2.16.7.1. HOIST CONTROL LEVER
- 2.16.8. OPERATOR SEAT
- 2.17. INSTRUMENT PANEL AND INDICATOR LIGHTS
- 2.17.1. CONTROL SYMBOLS
- 2.18. INSTRUMENT PANEL (FIGURE 37)
- 2.19. PANEL GAUGES, INDICATORS, AND CONTROLS (DISCUSSION OF ITEMS 129, FIGURE 36)
- 2.20. OVERHEAD STATUS/WARNING INDICATOR LIGHT PANEL (FIGURE 38)
- 2.21. INDICATOR LIGHT SYMBOLS REFER TO FIGURE 38 BY ROWS (AE) AND COLUMNS (16)
- 2.21.1. HAZARD WARNING LIGHTS (7)
- 2.21.2. LAMP TEST SWITCH (8)
- 2.22. LINKON WARNINGS LIGHT
- 3. MAINTENANCE
- 3.1. LUBRICATION AND SERVICE
- 3.1.1. SERVICE CAPACITIES
- 3.1.2. HYDRAULIC TANK SERVICE
- 3.1.3. COOLANT LEVEL CHECK
- 3.1.4. RADIATOR FILING PROCEDURE
- 3.1.5. COOLING SYSTEM RECOMMENDATIONS
- 3.1.6. RESERVE ENGINE OIL SYSTEM
- 3.1.7. LUBRICATION CHART
- 3.1.8. HOUR (SHIFT) LUBRICATION AND MAINTENANCE CHECKS
- 3.1.9. HOUR LUBRICATION AND MAINTENANCE CHECKS
- 3.1.10. HOUR LUBRICATION AND MAINTENANCE CHECKS
- 3.1.11. HOUR LUBRICATION AND MAINTENANCE CHECKS
- 3.1.12. HOUR LUBRICATION AND MAINTENANCE CHECKS
- 3.1.13. HOUR LUBRICATION AND MAINTENANCE CHECKS
- 3.1.14. HOUR LUBRICATION AND MAINTENANCE CHECKS
- 3.1.15. HOUR LUBRICATION AND MAINTENANCE CHECKS
- 3.2. LINCOLN AUTOMATIC LUBRICATION SYSTEM (ROTARY PUMP)
- 3.2.1. GENERAL DESCRIPTION
- 3.2.2. SYSTEM COMPONENTS
- 3.2.3. SYSTEM OPERATION
- 3.2.4. INJECTOR OPERATION
- 3.2.5. INJECTORS
- 3.2.6. GENERAL INSTRUCTIONS
- 3.2.6.1. LUBRICANT REQUIRED
- 3.2.6.2. SYSTEM PRIMING
- 3.2.6.3. FILTER ASSEMBLY
- 3.2.6.4. LUBRICANT PUMP
- 3.2.7. SYSTEM CHECK OUT
- 3.2.7.1. LUBRICATION CYCLE TIMER CHECK
- 3.2.8. SYSTEM TROUBLESHOOTING CHART
- 3.2.9. PREVENTATIVE MAINTENANCE PROCEDURES
- 4. SPECIFICATIONS
- 4.1. MAJOR COMPONENT DESCRIPTIONS
- 4.2. SPECIFICATIONS
- 5. OPTIONAL EQUIPMENT
- 5.1. PAYLOAD METER 3 (ON BOARD WEIGHTING SYSTEM (OBWS) INDEX)
- 5.1.1. OPERATION SECTION
- 5.1.2. INTRODUCTION
- 5.1.3. DATA SUMMARY
- 5.1.4. DATA GATHERING
- 5.1.5. COMPONENT DESCRIPTION
- 5.1.5.1. SYSTEM DIAGRAM
- 5.1.5.2. SUSPENSION PRESSURE SENSORS
- 5.1.5.3. INCLINOMETER
- 5.1.5.4. OPERATOR DISPLAY
- 5.1.5.5. OPERATOR SWITCH
- 5.1.5.6. SPEED INPUT
- 5.1.5.7. BODYUP SWITCH
- 5.1.5.8. BRAKE LOCK SWITCH
- 5.1.5.9. PAYLOAD METER
- 5.1.5.10. COMMUNICATIONS PORTS
- 5.1.5.11. KEYSWITCH INPUT
- 5.1.5.12. PAYLOAD METER POWER
- 5.1.5.13. LOAD LIGHTS
- 5.1.5.14. WIRING AND TERMINATION
- 5.1.5.15. TCI OUTPUTS
- 5.1.6. OPERATOR DISPLAY AND SWITCH
- 5.1.6.1. READING THE SPEEDOMETER
- 5.1.6.2. READING THE LOAD DISPLAY
- 5.1.6.3. USING THE OPERATOR ID
- 5.1.6.4. USING THE LOAD AND TON COUNTER
- 5.1.6.4.1. TOTAL TON COUNTER
- 5.1.6.4.2. TOTAL LOAD COUNTER
- 5.1.6.4.3. CLEARING THE COUNTERS
- 5.1.6.5. VIEWING LIVE SENSOR DATA
- 5.1.6.6. OTHER DISPLAY MESSAGES
- 5.1.7. PAYLOAD OPERATION CALCULATION
- 5.1.7.1. DESCRIPTION OF HAUL CYCLE STATES
- 5.1.7.1.1. STATES OR STAGES OF A TYPICAL HAUL CYCLE
- 5.1.7.1.2. HAUL CYCLE DESCRIPTION
- 5.1.7.2. LOAD CALCULATION
- 5.1.7.3. CARRY BACK
- 5.1.7.4. MEASUREMENT ACCURACY
- 5.1.7.5. SOURCES FOR PAYLOAD ERROR
- 5.1.7.5.1. PAYLOAD ERROR
- 5.1.7.5.2. LOAD CONDITIONS
- 5.1.7.5.3. PRESSURE SENSORS
- 5.1.7.5.4. SWING LOADS
- 5.1.7.5.5. SPEED AND DISTANCE
- 5.1.8. HAUL CYCLE DATA
- 5.1.8.1. HAUL CYCLE DATA
- 5.1.8.2. HAUL CYCLE WARNING FLAGS
- 5.1.8.3. ALARM RECORDS
- 5.1.8.4. FRAME TORQUE DATA
- 5.1.8.5. SPRUNG WEIGHT DATA
- 5.1.8.6. MAXIMUM SPEED DATA
- 5.1.9. PC SOFTWARE OVERVIEW
- 5.1.9.1. PC OVERVIEW
- 5.1.9.2. SYSTEM CONFIGURATION
- 5.1.9.3. INSTALLING THE PAYLOAD METER 3 SOFTWARE
- 5.1.10. DOWNLOADING DATA
- 5.1.11. PLM3 SYSTEM CONFIGURATION
- 5.1.11.1. STARTING COMMUNICATIONS
- 5.1.11.1.1. DISPLAYED PAYLOAD UNITS
- 5.1.11.1.2. TIME UNITS
- 5.1.11.2. CONNECTION MENU
- 5.1.11.3. CONNECTING TO THE PAYLOAD METER
- 5.1.11.4. CONFIGURE THE PAYLOAD METER
- 5.1.11.4.1. SETTING THE DATA AND TIME
- 5.1.11.4.2. SETTING THE TRUCK TYPE
- 5.1.11.4.3. SETTING THE GAUGE DISPLAY UNITS
- 5.1.11.4.4. SETTING THE FRAME SERIAL NUMBER
- 5.1.11.4.5. SETTING THE TRUCK NUMBER
- 5.1.11.4.6. SETTING THE KMS DISTRIBUTOR
- 5.1.11.4.7. SETTING THE KMS CUSTOMER
- 5.1.11.5. CLEAN TRUCK TARE
- 5.1.11.6. INCLINOMETER CALIBRATION
- 5.1.12. DATA ANALYSIS
- 5.1.12.1. CREATING A QUERY
- 5.1.12.1.1. SORTING ON A TRUCK UNIT NUMBER
- 5.1.12.1.2. SORTING ON A TRUCK TYPE
- 5.1.12.1.3. SORTING ON DATE RANGE
- 5.1.12.1.4. SORTING ON TIME RANGE
- 5.1.12.2. PAYLOAD DETAIL SCREEN
- 5.1.12.3. CREATING REPORTS
- 5.1.12.3.1. SUMMARY ONE PAGE REPORT
- 5.1.12.3.2. DETAILED MULTIPAGE REPORT
- 5.1.12.4. CREATING GRAPHS
- 5.1.12.5. EXPORTING DATA
- 5.1.12.5.1. CSV EXPORT
- 5.1.12.5.2. COMPRESSED
- 5.1.12.6. IMPORTING DATA
- 5.1.12.7. DELETING HAUL CYCLE RECORDS
- 5.1.12.8. VIEWING ALARMS
- 5.1.12.9. DELETING ALARM RECORDS
- 5.2. RADIO, AM/FM STERO CASSETTE
There are no reviews yet.