Komatsu WB140PS-2, WB150PS-2 Backhoe Loader Operation and Maintenance Manual WEAM002201

Description

• Model List:
  • WB140PS-2 Backhoe Loader
  • WB150PS-2 Backhoe Loader

• 1. COVER
• 2. TABLE OF CONTENTS
• 3. FOREWORD
• 4. INFROMATION ON SAFETY
• 5. INTRODUCTION
• 6. INTENDED USES
• 7. IMPROPER OR UNAUTHORIZED USES
• 8. MAIN CHARACTERISTICS
• 9. RUNNINGIN
• 10. PRODUCT IDENTIFICATION
• 11. MACHINE SERIAL NUMBER
• 12. MACHINE IDENTIFICATION PLATE
• 13. ENGINE SERIAL NUMBER AND EMISSION LABLE
• 14. FRONT AXLE SERIAL NUMBER
• 15. REAR AXLE SERIAL NUMBER
• 16. TRANSMISSION SERIAL NUMBER
• 17. CAB SERIAL NUMBER
• 18. CANOPY SERIAL NUMBER
• 19. SERIAL NUMBER AND DEALERS ADDRESS
• 20. SAFETY AND ACCIDENT PREVENTION
• 20.1. GENERAL PRECAUTIONS
• 21. PRECAUTIONS
• 21.1. PRECAUTIONS TO BE TAKEN BEFORE STARTING THE ENGINE
• 21.2. PRECAUTIONS TO BE TAKEN WHEN WORKING
• 21.3. TRANSPORTING THE MACHINE ON OTHER VEHICLES
• 21.4. THE BATTERY
• 21.5. PRECAUTIONS FOR EMERGENCY RECOVERY
• 21.6. PRECAUTIONS TO BE TAKEN DURING MAINTENANCE
• 21.7. SAFETY PLATES
• 22. TECHNICAL SPECIFICATION
• 22.1. TECHNICAL DATA
• 23. DESCRIPTION AND USE OF THE MACHINE
• 23.1. SAFETY LOCKS
• 23.2. GENERAL VIEWS
• 23.3. INSTRUMENTS AND CONTROLS
• 23.4. FUSES AND RELAYS
• 23.5. GUARDS, CAB AND DRIVERS SEAT
• 23.6. USE OF THE MACHINE
• 23.7. PARKING THE MACHINE
• 23.8. STOPPING THE ENGINE
• 23.9. TRANSPORTING THE MACHINE ON OTHER VEHICLES
• 23.10. PRECAUTIONS TO BE TAKEN IN THE COLD SEASON
• 23.11. PRECAUTIONS TO BE TAKEN IN THE WARM SEASON
• 23.12. USING THE MACHINE AS A LOADER
• 23.13. USING THE MACHINE AS AN EXCAVATOR
• 23.14. TROUBLESHOOTING
• 24. MAINTENANCE
• 24.1. GUIDE TO MAINTENANCE
• 24.2. MAINTENANCE NOTES
• 24.3. FUEL, COOLANT AND LUBRICANTS
• 24.4. NUT AND BOLT TIGHTENING TORQUES
• 24.5. MAINTENANCE PLAN
• 24.6. LONG PERIODS OF INACTIVITY
• 25. AUTHORIZED OPTIONAL EQUIPMENT
• 25.1. AUTHORIZED OPTIONAL EQUIPMENT
• 25.2. FRONT EQUIPMENT RAPID COUPLING DEVICES
• 25.3. MULTIPURPOSE BUCKET
• 25.4. PALLET FORKS
• 25.5. BACKHOE TELESCOPIC ARM
• 25.6. ARRANGEMENT FOR THE INSTALLATION OF THE DEMOLITION HAMMER
• 25.7. ARRANGEMENT FOR THE OPERATION OF OPTIONAL EQUIPMENT WITH UNIDIRECTIONAL OIL FLOW
• 25.8. ARRANGEMENT FOR THE INSTALLATION OF THE CLAMSHELL BUCKET
• 25.9. ARRANGEMENT FOR THE INSTALLATION OF THE MANUAL HYDRAULIC HAMMER
• 25.10. LOAD STABILIZER SYSTEM (LSS) (OPTIONAL)
• 25.11. AIR CONDITIONER (OPTIONAL)