Description
-
Model List:
- D375A-6 Bull Dozer
- 1. COVER
- 2. Preface
- 3. CONTENTS
- 4. Specifications
- 5. Precautions for field assembly
- 6. Disposal of removed parts
- 7. Assembly procedure, necessary equipment, and schedule
- 8. Layout of kit
- 9. Style for transportation
- 10. Table of tools for field assembly
- 11. Tightening torque
- 12. Coating materials list
- 13. Selection of wire ropes used for assembly
- 14. Assembly
- 14.1. A1 Installation of chassis
- 14.2. A2 Installation of undercarriage
- 14.3. A3 Adding oil to recoil chamber and pivot chamber
- 14.4. A4.1 Installation of engine air inlet hood
- 14.5. A4.2 Installation of engine air precleaner (if equipped)
- 14.6. A5 Installing direction of exhaust pipe
- 14.7. A6 Installation of highmount head lamp (if equipped)
- 14.8. A7 Installation of blade lift cylinder
- 14.9. A8 Installation of cylinder yoke grease hose (if equipped)
- 14.10. A9 Installation of ripper
- 14.11. A10 Installation of right and left service center boxes at rear of fenders (if equipped)
- 14.12. A11 Installation of grease hose of ripper pin (if equipped)
- 14.13. A12 Installation of track
- 14.14. A13 Assembly of blade
- 14.15. A14 Installation of grease hose of blade joint (if equipped)
- 14.16. A15 Installation of blade
- 14.17. A16 Installation of operators cab
- 14.18. A17 Installation of rear monitor camera (if equipped)
- 14.19. A18 Installation of additional cab lights (if equipped)
- 14.20. A19 Installation of ROPS guard
- 14.21. A20 Installation of VHMS, ORBCOMM antenna (if equipped)
- 14.22. A21 Installation of platform (if equipped)
- 14.23. A22 Check track tension
- 14.24. A23 Check fuel, coolant and lubricants
- 14.25. A24 Bleeding air from hydraulic cylinders
- 14.26. A25 Lubricating
- 14.27. A26 Installation of fuel quick charge piping (if equipped)
- 15. Check and maintenance procedures after completion of assembly
- 15.1. M1 Check and adjustment of operators cab
- 15.2. M2 Inspection of machine monitor
- 15.3. M3 Checking operation of dual tilt mechanism (If equipped)
- 15.4. M4 Setting procedure for USER ADJUST MODE
- 15.5. M5 Setting procedure for maximum cooling fan speed
- 15.6. M6 Check of engine emergency stop switch
- 15.7. M7 Check of operation of lamps
- 15.8. M8 Replacement of return filter (Replacement of standard filter > special flushing parts)
- 15.9. M9 Flushing of hydraulic circuit, and bleeding air from hydraulic cylinders (Part 1)
- 15.10. M10 Replacement of return filter (Replacement of special flushing parts > standard filter)
- 15.11. M11 Bleeding air from hydraulic cylinders (Part 2)
- 16. APPENDIX 1. Installation procedure for spill guard (Installation by welding)
- 17. APPENDIX 2. Precautions for initialization procedures for VHMS controller
- 18. Field assembly inspection report
There are no reviews yet.